I\'m working on an existing driver that controls an 8-bit MCU over a serial port.There are many different flavors of firmware for the MCU but they all share a common method of trying to ensure link in
I have written the following code to configure the serial port when the MainForm loads. On first run it gives IOException when port is opened, stating that the parameter is incorrect. But when I re-st
I have this code for sending file size from linux machine to embedded device: #send length device_port = s开发者_开发知识库erial.Serial(\"/dev/ttyUSB1\", 115200, timeout=3)
Background information: I have been writing code to control a device attached by a USB cable but emulating an RS-232 serial port.
I am looking into the possibility of developing a Tegra based robotics platform running Android. To do this I need to be able to preform serial, I2C, and possibly PWM communications, does the Teg开发者
I am writing \"AT\" commands to a GSM modem via an RS 232 serial port for sending messages. I am doing so in a \"for\" loop and i need to know how to reduce the delay that i need to provide in the for
This is very frustrating as I\'ve been trying for weeks and not even a clue on the internet. I am working on a project that reads/writes bluetooth serial data on different farming hardware.
I could try to open it, but if it is use by another program I will get an error and I ne开发者_如何学编程ed to be able to distinguish that case from the case where the machine physically has no serial
suppose an application (not me!) has opened a Serial port (COM1) , and i do not have access to it\'s handle (or something like that) and i don\'t know...
Is it possible to read the reply from a serial port right after sending a command in C#?I have a stepper motor driver and am trying to read the current step number and display it in the status bar of
加载中,请稍侯......