Please consider the following example (tried on Arduino IDE 0022, Ubuntu 11.04, Arduino AtMEGA 2560), where I\'m trying to start a timer/counter interrupt and use the Arduino Serial class at the same
I\'ve attached my code below (I\'m blinking a LED to be able to see that the loop is occurring BTW). I am not getting any data sent out over the UART, I have the Pic 16F913, and pin 17 is the output
I am looking for ideas for a receive buffer for a small application dealing with 15 byte packets at 921.6Kbaud over rs485. I开发者_如何学JAVA am thinking of using a circular buffer as the interface be
i have a problem with pic18f452 and uart i use simplest code like that: UART1_Init(9600);// Initialize UART module at 9600 bps
My title describes my problem... Can\'t do anything to solve it. It is a serial COM device connected via USB cable (appropriate driver is installed).
I am trying to recieve 1 character using the USART feature on PIC 16. Both the transmitter and receiver are both PIC 16s.
I am trying to interface to a microcontroller from my linux box via RS232 serial. I have written the driver and implemented a prot开发者_如何学运维ocol b/n pc and microcontroller, which uses a tty(/d
Just trying my hands on FreeRTOS. 开发者_Go百科Following are my setup - Micro-controller - AT32UC3A0512
I want to modify my linux kernel\'s (2.6.32) UART driver.I am using the standard开发者_高级运维 uart driver for ttyS2 I dont know the exact files.The problem is Simple, setting and keeping a gpio pin
I\'m writing a RS485 driver for an ARM AT91SAM9260 board on Linux. When I initialise the UART, the RTS signal line gets high (1). I guess this would and should be the standard behaviour in RS232 ope
加载中,请稍侯......