Reading data using tn.read_all() in python

read_all()" to read data from a cisco device. some time it reads the data and sometime it won't read and gives empty string. I tried below 2 commands but still it's not consitently reading data.

data=tn.read_until("exit")
data= tn.read_all()

please give some inputs i am new to python.

code i am using:

_command2='show chassis'
    print 'Commands issued............'
    #ISSUE COMMANDS VIA TELNET    
    tn.write("term len 0\r")
    #tn.read_until(" ")    
    #tn.write(_command1+"\r")   
    tn.write(_command2+"\r")
    tn.write("exit\r" )
    print 'Read telnet data............'
    #READ TELNET DATA
    #data=tn.read_eager()
    data=tn.read_until("exit")
    #data= tn.read_all()
    #print data
    print 'Telnet data read successfully......开发者_如何学JAVA......'

I too faced the same problem..This would help:

tn = telnetlib.Telnet('64.0.0.1')
tn.write('ls \r\n')
data = '' 
while data.find('#') == -1:
    data = tn.read_very_eager()
print data

This snippet reads the info after a command being executed. And reads till '#' prompt is shown.

Short answer:

Use time.sleep(1) in between write commands

Long answer:

When you enter a command on a Cisco IOS console, it blocks until the command completes. Any input you enter into the console while the command was running is piped into the running command, much like STDIN works on a bash shell. However in bash, if a commands doesn't explicitly read the input, upon the exit of the program bash takes the unconsumed input and interprets it as a shell command. So if you want to run two commands one after another, where the first command does not read from STDIN, you can enter the second command while first command is running, i.e. you don't have to wait for the first command to finish before you enter another command. This sort of a buffering mechanism makes telnet scripting easy and we have grown to expect this from mature shells. Apparently Cisco IOS lacks this feature, and so you have to make sure you don't enter your commands too soon. There are two ways I can think of, to go about it:

1. Wait for a fixed amount of time between commands. Usually 1 second is a safe bet for most commands.
2. Parse the output after each command until you find the prompt, then enter the next command, then parse again, and so on.

Use:

tn.read_very_eager()

instead of tn.read_all() - read_all waits until the connection is closed

@yogi 's answer is almost right. but some details to be explained

data = '' 
finish = '' #m1
while data.find(finish) == -1:
    data += tn.read_very_eager() # m2
print data

m1: there is what your telnet server returns when command finished

m2: there should be +=, because some command results has several lines