cURL/PHP Request Executes 50% of the Time

After searching all over, I can't understand why cURL requests issued to a remote SSL-enabled host are successful only 50% or so of the time in my case. Here's the situation: I have a sequence of cURL requests, all of them issued to a HTTPS remote host, within a single PHP script that I run using the PHP CLI. Occasionally when I run the script the requests execute successfully, but for some reason most of the times I run it I get the following error from cURL:

* About to connect() to www.virginia.edu port 443 (#0)
*   Trying 128.143.22.36... * connected
* Connected to www.virginia.edu (128.143.22.36) port 443 (#0)
* successfull开发者_开发技巧y set certificate verify locations:
*   CAfile: none
  CApath: /etc/ssl/certs
* error:140943FC:SSL routines:SSL3_READ_BYTES:sslv3 alert bad record mac
* Closing connection #0

If I try again a few times I get the same result, but then after a few tries the requests will go through successfully. Running the script after that again results in an error, and the pattern continues. Researching the error 'alert bad record mac' didn't give me anything helpful, and I hesitate to blame it on an SSL issue since the script still runs occasionally.

I'm on Ubuntu Server 10.04, with php5 and php5-curl installed, as well as the latest version of openssl. In terms of cURL specific options, CURLOPT_SSL_VERIFYPEER is set to false, and both CURLOPT_TIMEOUT and CURLOPT_CONNECTTIMEOUT are set to 4 seconds. Further illustrating this problem is the fact that the same exact situation occurs on my Mac OS X dev machine - the requests only go through ~50% of the time.

The remote host is maybe not a real unique host. Maybe it's some sort of load balancing solution with several servers taking the incoming requests. What make me think it could be that is the 'mac error' in the error message. This could mean the remote host mac address as changed while the SSL negociation was still running. And this could explain that sometimes you do not have any problem.

But maybe not :-) SSL problems are quite hard to find.

I do not understand your answer on prefork MPM vs Worker MPM, if you run PHP in cli mode your apache MPM is not used, you're not even using apache.

You may need this option:

CURLOPT_FORBID_REUSE

Pass a long. Set to 1 to make the next transfer explicitly close the connection when done. Normally, libcurl keeps all connections alive when done with one transfer in case a succeeding one follows that can re-use them. This option should be used with caution and only if you understand what it does. Set to 0 to have libcurl keep the connection open for possible later re-use (default behavior).

Had you tried? curl_setopt($handle, CURLOPT_SSLVERSION, 3);