Strange jump in MIPS assembly

I'm probably missing something really obvious here, but I've been going over this over and over and I'm decidedly stuck. In the code below, $8 is incremented only if $2 != $0. Now I double and triple checked and the b开发者_如何学Ceq instruction works (for example if I change lop to end2, it does go there).

However, for some reason, $8 is incremented regardless, even if the branch is executed.

lop:   beq $3, $0, end2
       and $2, $3, $4

       sll $3, $3, 1

       beq $2, $0, lop     

       addi $8, $8, 1

       j lop

I've got to admit I'm completely stumped.

(The and after the first beq will always be executed, too.)

MIPS has explicit pipeline hazards; by the time the decision to branch (or not) is made, the following instruction has already progressed far enough through the instruction pipeline that it will be executed regardless. This is known as the "branch delay slot".

In some cases you can arrange code to take advantage of this; if you can't (or don't want to), you can just put a nop in the following instruction.

Some assemblers will reorder code (or fill in the nop) for you - e.g. gas, the GNU assembler, does, unless you tell it not to with a .set noreorder directive. But you still need to be aware of it when disassembling anyway.

If you're writing code without automatic reordering by the assembler, I recommend annotating the delay slot with some extra indentation to make it stand out:

lop:   beq $3, $0, end2
         nop
       and $2, $3, $4

       sll $3, $3, 1

       beq $2, $0, lop     
         nop

       addi $8, $8, 1

       j lop

The add instruction is occurring in the branch delay slot of the beq.