Korg Nanokey MIDI Controller for Arduino?

I have a Korg NanoKey which I'd like to use to control a simple synthesizer I've designed on the Arduino platform. (I have an Arduino Uno.) Basically, I don't care about MIDI, I just want to read what note the keyboard has pressed dow开发者_开发技巧n, but if MIDI is the only way I can do that, then it's okay with me. So my big question is, how do I do this? I haven't been able to find anyone else on the Internet who has already done this.

But more specifically, I see two challenges: First, I'd like to plug my NanoKey directly into the Arduino's USB port, but then I'm wondering if the Arduino would provide the necessary power to the NanoKey. Second, I'm not sure what protocol I would be reading. Can I just read MIDI signals as described in this tutorial?

I don't want to curb your enthusiasm but what you're attempting might be a bit hard basket. A USB system consists of a host controller and one or more peripheral devices. It's the host that controls traffic flow to the devices which means that devices can't transmit data on the bus without an explicit request from the host controller.

I'm not familiar with either the nanoKey or the Arduino platform but I'd be fairly confident that the nanoKey is a USB "device", normally connected to a computer which would act as the host. So what you would need for this system to work is for the Arduino to act as the host when communicating with the nanoKey. The Arduino schematic shows that the Arduino Uno uses an ATmega8U2 for USB coms. Unfortunately the ATmega8U2 is a USB device, so you've got two peripheral devices but no host controller to facilitate the transfer of data between them. You'd be better off using a development board for a micro that provides either USB Host or USB On-the-Go.

I opened up a Korg Nano controller yesterday and was surprised to discover that there's an AVR mega32 inside. It would be a significant undertaking, but with a bit of work you could probably work out the schematic and reprogram it yourself using their programming header breakout. You might not end up with much more functionality than you've got this other way, but it would be very educational.

I agree with the Jono - you are biting off a lot - it might even end up easiest to hook the keys up to the Arduino directly - tearing out the electronics and figuring out a way to multiplex the keys into a single channel without losing polyphony (resistor 'ladder' maybe). I any case, good luck. Amusingly, you'd making an analog keyboard to plug into a digital synthesizer.

Quick and Dirty Arduino MIDI Over USB demonstrates how to send/receive MIDI out over USB, but unfortunately, this probably isn't any help for what you are trying to do, since he's found a way to send and receive MIDI signals from a USB host, not act as a USB host himself - the opposite of your problem. However, I thought perhaps it would be of use, if you ever wanted to control your device from a computer.

As mentioned in the other posts, you would need to use a separate chip to provide the USB Host interface. Here's a great guide to using the USB Host shield by Circuits@Home to interface with an Akai LPK25 (USB Midi Keyboard).

http://blog.makezine.com/2010/11/30/usbhacking/

The Arduino sketch is provided, so you should be able to try it out, however debugging the USB Host connection could get tricky real fast if it doesn't work out of the box.